Replace Windows on Your Own

In today’s world where everyone is greatly suffering from huge economic crisis, majority of people are thinking of ways on how to save more money by starting on cutting their electricity bills. A good way to start on this is to replace old and dilapidated windows. It can initially be such a daunting task for anyone but it actually takes a few simple steps to make it a success.

Majority of windows today are situated inside their own case, and all that you need to do is to pop it to the old hole. Probably the toughest part in the process is to be precise of all the measurements and the actual removing act of the dilapidated window. Remember to not push through with the procedure of replacement if you are still unsure of the installation of the new windows.

In this do it yourself project, your first step would be to take the proper measurements. You need to be sure of the measurements since you will need it in buying the new window. The window jamb will be your basis for the measurements and this is the flat section which the window sashes crashes against. Take the measure first between the two jams at three angles.

Once you are done, deduct it by ¼ inch from the smallest measurements of the three angles. Do the same for the measurement of the height by starting from the bottom right at the back of the sill and the top part where the upper stash ends.

Next step would be about measuring the new windows that you will replace. When you fail in this aspect, you can expect that it won’t be a perfect fit in the previous hole. You need a hammer and a flat bar to take out the front part of the stop trim where you can see the borders inside. You need to take the time to take off this trim for you to remove the sash without causing much hassle. If you happen to have the traditional windows, you have to take out too the rope weights. Just be sure to not remove the trim at the bottom since this will be the one to hold the new window firmly in place.

The final step of the new windows installation would be the setting of the bottom part of it, just above the sill. You will be needing wood shims and mounting screws that are already provided on your new window’s jamb. Make sure to stick any insulation into the holes before placing back the trims. Finishing touches would just require you to caulk completely to avoid any air leaks.

As described above, it really won’t take much for you to do your own window replacements. They will help you too in saving more money on your bills for electricity.

Find out more about replacing windows here.