Important Tips on Installing Drawer Pulls

Most of you might have realized, how irritating it can be to use a drawer without a handle. There is no doubt that they make the usage of a drawer more convenient, but only few realize that installing the right handle (or knob) on your drawers, can enhance the visual appeal of a home. There are a large variety of drawer pulls to choose from, so, you should never be in a hurry to choose the one for your drawers. You can begin your search from the nearest home improvement store, or you can start online. Once you find the desired type of drawer pulls, with the right measurement, then it is time for you to install them.

How to Install Drawer Pulls

If you are replacing the existing drawer pulls, then it will be very easy for you. You just have to remove the old handles (or knobs), and install the new ones carefully (you do not have to bother about positioning and drilling). If you are installing drawer pulls for the first time, then it will be a little difficult for you, but you do not need to worry, I am here to guide you. In addition to the drawer pulls, here is a list of the things that you will require:

• Tape measure
• Masking tape
• Pencil
• Drill
• Screws
• Flat-head screw driver

All set? Let us begin.

Positioning
I believe that, if the drawer pulls are not positioned right, then there is no point in installing them. So, it is very important that you position the drawer handle in such a way, that your convenience is multiplied. If you do not want to stick to the conventional central position of the drawer pulls, you can surely experiment with different positions, but remember that you have a set of drawers, so whatever you do should look good on all the drawers. Once you have finalized the position, use a tape measure and a masking tape to mark the location, and then use a pencil to mark the drilling spots on the masking tape. Make sure that the drilling spots are aligned properly (especially if you are going to install handles).

Drilling
Before you start drilling, wear your protective eye gear. Now, slowly drill a hole in a drawer from outside to inside (and not the other way round), at the spot(s) marked for drilling. Now, put a screw in that hole, and make sure that the hole is right for the screw, then install the drawer pull, tighten the screw using a flat-head screw driver. If you feel that the pull is loose, then try using washers. If the problem is not solved, then you might have to use shorter screws. Similarly, install all the other drawer pulls. After you are done, inspect whether the pulls are secured to the drawers.

Things to Remember

• Provide the right measurements when shopping online.
• See that you maintain uniformity in the alignment of the pulls.

You may observe, that installing pulls is not a difficult task, but if you lack precision in positioning, you will end up ruining your drawer. So, avoid impatience! You can do the installation all on your own, but I recommend you to have some company while you are working, as a second opinion about the alignment of the drilling spots can be very helpful sometimes.

While installing, if you find that a pull has a defect, do not hesitate to ask for a replacement. Once you are done installing the drawer pulls, do not forget to do regular maintenance checks. I am sure that the drawer pulls will surely make your life a bit easier.