How to Open a Pool

The chilly winter is passing by and summer season is once again approaching. It's the time to revamp your indoor swimming pool so that you can spend hours relaxing in the serene blue water. Opening a pool after a long duration is a little daunting task. If you are planning to take it as a DIY project, then it's gonna be quite hectic. However, it will save a considerable amount of expenses. The steps to open a swimming pool will be explained in the content written below.

Steps to Open a Pool

Read the steps mentioned below and get to know how to open a swimming pool. Procure all the materials before you engage into the task of opening your swimming pool. This includes pool water test kit and pool chemicals. You need to perform a few steps before opening the pool cover. Check them.

Step # 1
Follow these pool draining tips for draining water from the top of the cover before opening it. Drainage of excess water on the top is carried out with the help of a pump. Since the pool was not used for a long period there might be accumulation of dirt, leaves and dirt. Make sure they do not fall in the pool. Sweep them carefully and use a leaf blower to remove the sticks, twigs and debris from the top of the cover.

Step # 2
Removing the safety cover from the pool is difficult. You will require a removal tool for loosening the screws and then removing it. After removing the cover, wipe off the dirt with the help of your garden hose. Before replacing the pool cover, ensure that it is completely dry. The next step will deal with reconnecting the equipment before adding water to the pool.

Step # 3
Reset the circuit if you have switched off the power breaker of the pool. Open the valves after attaching the filtration hoses and then place the filter cartridge. This process should strictly follow the guidelines mentioned for operating the heater, filter and the pump of the swimming pool. Remove the winterizing plugs, lubricate the rings and other appliances with a waterproof lubricant.

Step # 4
The water level should cover at least 3/4th of the skimmer. Do not forget to prime the pump before turning on the motor. Remove every traces of air from the equipment and check for leakages. The pool should be completely clean or else start the cleaning process once again. Clean the pool of algae, leaf debris, sand and other materials.

Step # 5
You must properly know the swimming pool chemical treatment methods. Analyze the water chemistry before filling water. You can do this, by taking a sample of the pool water to a professional and get a check done for the alkalinity, hardness, acidity and pH. Never throw chlorine in your pool water. The newly added water should circulate for 10-12 hours for adequate mixing with the pool water. You can balance the water chemistry after carefully reading the instructions mentioned on the pool kit.

Step # 6
This is the last step in the process. Finally, you are going to use your swimming pool once again. Install the ladders and handrails properly. Make sure that the diving boards have non-skid surfaces. Get the tips on home pool maintenance. Keep the equipment clean so that the water is not polluted. You can also apply a corrosion resistant car wax on the rails for increasing its durability. Thus, your swimming pool is ready.

Even if you handle the project by yourself, it will still involve some investment. Therefore, the question is, 'how much does it cost to open a pool'. Well, a DIY project will always save some expenditure as an external aid is not required. However, you cannot avoid the expenses incurred on buying chemicals, electricity bill and the maintenance cost. Chemicals will cost you nearly around US$ 150-US$ 300 while electricity spent on running water pumps goes to around US$ 50-US$ 65 per month. Maintain the pool and keep it unhygienic.