Half Water Half Gas - Water for Gas HHO in 3 Easy Steps

1. Half Water Half Gas – How Water for Gas HHO Units Work
Super easy, Your engine only uses 20% of the energy stored in that expensive fuel and wastes 80% for heat, pollution (unburned fuel!) and general vibration. Water on the other hand is a much more powerful and efficient fuel, all you need is the right match and kaboom.

The overview that you are about to read will get you well on the way to constructing your own HHO cell out of basic materials that you can find at your local hardware store, once constructed and fitted your vehicle will start safely using water for gas by running on at least fifty percent hydrogen which is safely produced by the water for gas device you will soon build. You will need detailed instructions on how to assemble your HHO cell. The instructions that I use, which you are welcome to use too, have enabled me to build a total of eleven half water half gas HHO devices, 3 of which are in large trucks. In all situations fuel economy more than doubled and after just one days running all vehicles that ran the half water half gas fuel mix ran quieter, cooler and smoother.

2. Half Water Half Gas – Building Your First Water for Gas HHO Cell
To run your car or truck on half water half gas you will need to build what is now known as a HHO cell. This is the unit that will produce the hydrogen gas needed to power your vehicle on half water half gas. While this sounds incredibly hard to build in reality it is the opposite. This is a simple water for gas device that has been suppressed for more than ninety years. Here are some of the different types of parts you will need in order to start building your half water half gas HHO unit. A 950cc glass jar with plastic lid, super glue, vacuum hose and T joint, electronic wiring harness, brass fuel heating fitting, pure baking soda, distilled water and a dual edge map sensor enhancer all of which you will be able to buy for peanuts at your local hardware store.

3. Half Water Half Gas – Assembly & Install of the Water For Gas HHO Cell
Once you have the necessary parts it takes approximately one hour to assemble your half water half gas HHO unit, even if you have never done anything like this before. You will be quite surprised at to how quick your water for gas HHO unit will come together, I was.

You are basically just drilling 4 holes in the lid from a pattern that you print out , bonding some tubes in place and assembling your wire electrode coil. Honestly, it couldn’t be easier, the instructions explain everything in fine detail. Next you want to install your newly built water for gas HHO unit in a safe place in the engine bay, I have mounted all of mine on the firewall. Hooking it up takes a total of about fifteen minutes as you only have two hoses to plug in and four wires to connect before you are able to start your car and drive away. No tuning is needed when using water for gas as the map sensor enhancer adjusts the computers analysis of the fuel ratio.

When you choose to run your car by using water for gas you are going to wipe at least fifty percent off your fuel bill and that’s a fantastic thing but when you run half water half gas you are helping save the planet we inhabit and that’s even better.

For an instant copy of the instructions that I use plus videos showing these devices being built and actually working just visit Best Fuel Saver Product or if you would like to review the safety information on water for gas first then visit this link.