Car Stereo Installation Instructions

Bored with your old car stereo? Thinking of upgrading it? Aftermarket car stereos are much better in quality than the pre-installed car stereos. Car stereo installation is not a difficult job and can be accomplished in an hour or so! Basic knowledge of electrical wiring and automotive repair is all that is needed for installing a car stereo. So, to know how to install a car stereo, let us read the step by step car stereo installation instructions.

How to Install a Car Stereo?

Car stereo installation can be a fiddly job and can get you messed up totally! However, following the car stereo installation instructions given below, you will be able to swap the stereos in no time, without much trouble. Moreover, you will end up saving money, by avoiding the car stereo installation cost.

Things Required:

• Screwdriver set
• Wire cutters
• Wire strippers
• Socket wrench
• Electrical Tape

Car Stereo Installation Instructions:

Step 1: The most important thing to consider while car speaker installation, is to purchase the stereo that fits properly in the existing slot of your car. Also, do not forget to buy the correct wiring harness and a radio mounting kit.

Step 2: Now, before installing the car stereo, you will have to remove the old one carefully. For that, you need to disconnect the ground cable from your car battery. It is highly dangerous to work on the electrical system of the car with the negative wire, or the ground cable plugged in.

Step 3: Carefully remove the dash panel to expose the old stereo. Using the right screwdriver, unscrew and slide out the old head unit. Unplug and disconnect all the wires attached to the old stereo. Remove the old stereo carefully and disconnect the old panel.

Step 4: If you have got a wire harness specific to your car, the task becomes extremely simple, as you just have to connect the wires at the back of the new stereo. Plug the connector in the right place in the new stereo.

Step 5: If you were unable to get a wire harness, you will have to connect each wire yourself. Make sure to connect the wires to the respective connectors, according to their polarities. Connect the positive wires from the speakers to the positive connector, present at the back of the stereo. Similarly, connect the negative wires to the negative connector.

Step 6: Once the speakers of the new stereo are connected, you will have to connect the negative wire of the stereo to a bolt, near the dash, where the radio is mounted. You can refer to the car stereo installation manual, to make sure the connections made are right.

Step 7: When all the wires are properly connected to their respective connectors, hook the wires to a single connector.

Step 8: The new stereo is all set to be mounted on the rack. Slide it into the mounting bracket carefully. Now, plug the harness connector into the back of the new stereo.

Step 9: Slide the stereo into the space in the dash and test your new car stereo. If its working fine, it's time to put the dash panel back. Screw it back with the help of a screwdriver.

Step 10: Reconnect the ground cable to your car battery and turn on your car. Your new car stereo is now installed and ready to play loud!

This was all about car stereo installation. Installing a car stereo is not all that difficult as you just saw! So get a brand new stereo, gather all the tools and get ready for a rocking car audio system, by just following the simple car stereo installation instructions given above!