Cabinet Crown Molding Installation

Traditionally crown moldings were used as decorative trim in the area where the walls and the ceilings of a room meet. It was helpful to conceal any imperfections in this area. Today crown moldings are not just used in walls and ceilings but also used for decorating doors, windows and cabinets. It gives a beautiful decorative touch to a room or furniture. Using crown moldings on kitchen cabinets is a great way to transform the look of a boring and utilitarian piece of furniture. The best thing about using cabinet crown molding ideas is that it costs very less to update the kitchen cabinets. Crown moldings are available in a variety of designs as well as material. For this project choose a molding that matches with the kitchen decor.

How to Install Kitchen Cabinet Crown Molding

One of the most challenging aspects of installing cabinet crown molding is that you need to cut the crown molding with precision. The corners of the cabinet where the crown moldings meet should be perfectly aligned, otherwise the kitchen will look out of proportion. You also need to find the right color of crown molding for the kitchen cabinets that goes with the wall colors and the color of the cabinet.

Things required

• Crown molding
• Miter saw
• Measuring saw
• Hammer
• Nails

Procedure

The first thing that you need to do for kitchen cabinet crown molding is to measure the length, width and height of the cabinets. Double check to make sure that you have the exact measurements. Do not make the mistake of taking approximate measurements. The next step toinstall crown molding is to observe the clearance between the kitchen cabinets and the ceiling so that you do not end up buying crown moldings that are too wide for your cabinets. Once you are done taking the measurements, go to a home improvement store and purchase the crown molding. You can find cheap crown molding in annual sales of home improvement stores. Besides aesthetic points like color and design of the molding, you need to figure out how much molding you are going to need.

The shop assistant can probably help you in that. Always buy more crown molding then you will be needing. This is a very good policy to follow because you might make some mistake while cutting the molding and then you will need more molding. The next step is cutting and installing crown molding according to the measurements that you have taken. This is one of the most difficult parts of the project as cabinet crown molding cuts are notoriously difficult to make. The best way to make the cut, is to first hold the crown molding over the top edge of the kitchen cabinet and then mark the other end of the crown molding. Remove molding from the cabinet and turn it upside down before placing it on the mitered saw. Cut the molding at a clean and precise 45 degree angle at the marked spot. Cut the other three sides of the crown molding for the kitchen cabinet in the same way.

When you are done with cutting all the required pieces of molding, place them over your cabinet to make sure it all fits seamlessly. If any piece needs any adjustment, do it now. Next fasten the moldings to the cabinet with the help of nails and a hammer. Make sure that the crown molding is properly fastened. In case the nail holes are noticeable, fill them up with wood fillers.

Installing trimmings like crown moldings is a great way to add elegance and beauty to your kitchen cabinets.