Aluminum Window Replacement

Older houses generally have single pane aluminum windows installed. There is a single pane of glass which tend to be less energy efficient as compared to other windows. The new window would normally include two replacement panes that are divided with a layer of insulator. Once you decide how many windows need to be replaced, perhaps you have only one aluminum window replacement or more than one, you can go about getting the estimate of the entire project. Also, it helps manage time as you don't want to keep running back and forth from the store. The instructions explained below will give you a proper analysis of you should go about finishing the replacement of the window.

Replace Aluminum Windows

Before starting any home improvement project, you have to do some homework about it. The best way is to go to your local stores and ask for suggestions on what kind of window types would be best for this job. This idea will also help you understand what kind of energy saving windows you might want.

Materials Needed

• Tape measure
• Sealant
• Reciprocating saw
• Drywall
• Insulation
• Hammer

Step #1: First of all, you will need to get the measurements of the old aluminum windows. Instead of doing guesswork, this is the best way to get the correct size from your local home improvement store. Buy the replacement window according to your custom requirements.

Step #2: You need to remove the old aluminum window off the wall and look for how it was installed in the first place. Take a look at what tools might be used to perform the task. Sometimes, the windows have been bolted with screws in the studs that needs to be cut.

Step #3: To start your aluminum windows repair, try to (carefully) pull the old window off the wall. If you find any debris like nails and/or bits of paint, take the reciprocating saw to clean the area properly.

Step #4: To finish installing the window, keep the new window inside the opening of the wall. It needs to be secured in with the studs. Now, according to the size of the new window, it will need approximately 2 - 3 screws to secure each side.

Step #5: The insulation and the drywall needs to get placed around all the sides of the window. Apply a thin layer of sealant from inside and outside, around all the edges of the window. This will aid in stopping any kind of leaks all year round.

Tips for Replacing Aluminum Windows

• During winters, clean the new window(s) before the temperatures get low. This will help in minimizing your electricity bill and usage.
• If you want to apply fresh paint over the frames, then clean any residue of the sealant.
• When you're outside the house and working on the insulation and drywall, make sure the ladder that you've stepped on is on firm soil or steady surface.
• Always wear gloves and eye glasses while working as it is a necessary safety precaution.

We have another article on installing replacement windows which you might want to review for more details.

The above mentioned aluminum windows replacement instructions are for a single aluminum window. If you have more than one replacement project (probably around the house), you can follow the same steps that are provided in the article. Be careful while using the reciprocating saw to remove the debris, as it may fly everywhere. Wear some eye protection glasses so that you don't get any dirt/dust in the eyes.